Barco DX-700 - Manual (Page 182)

182 DX-700 • User’s Guide • Rev 02
^K==péÉÅáÑáÅ~нбзел
Pinouts
mêçéêáÉí~êó=asfJf=`зееЙЕнзк
The figure below illustrates the proprietary DVI-I connector, which is used for the following
connection:
• DVI Output Module: LED OUT 1, 2, and 3 connectors
Figure A-3. Proprietary DVI-I connector
1 8
9
17 24
C1 C2
C3 C4
C5
Warning The DVI-I connectors on the DVI output module use
proprietary signals and pinouts.
Do not connect the output of a DVI output module to anything
other than the input of a Barco DVI LED tile. Even though the
connector is a DVI-I type connector, it is not a DVI signal, and
serious damage could result if, for example, the output was
plugged into a DVI-type monitor.