Barco DX-700 - Manual (Page 24)

24 DX-700 • User’s Guide • Rev 02
NK==fåíêçÇìÅíáçå
About the DX-700
råÇÉêëí~еЗбеЦ=_~евл
DX-700 supports a wide number of flexible system configurations. Input and output
modules are installed in “banks,” consisting of one or more input modules and either one or
two output modules (with two being the maximum allowed in a bank). By definition, a bank
is a way of combining inputs and outputs into independent video processors that are
capable of driving one or more LED walls.
A single DX-700
=
supports both single and multi-bank configurations, as detailed below.
• Single Bank Configurations
• Multiple Bank Configurations
páåÖäÉ=_~ев=`зеСбЦмк~нбзел
The figure below illustrates two examples of single bank configurations:
Figure 1-5. Single bank configuration examples
Please note the following points regarding single bank configurations:
• A single bank has a maximum “canvas” size of 2048 x 1080 pixels (or 1080 x
2048 pixels). This overall region can be divided as required between three
outputs (using one output module), or six outputs (using two output modules).
• From two to six physical outputs can be “grouped” electronically to form a larger
“logical” output. This grouping enables you to control a larger LED display —
larger than is possible with a single output. Refer to the “
Grouping Outputs ”
section on page 26 of this chapter for more information.
• Based on seven slots for input and output modules, you can use up to six input
modules in a bank with one output module, or up to five input modules in a bank
with two output modules.
Numerous output combinations are possible within a single bank — because each output
can be driven independently or grouped with other outputs. Remember that a maximum of
two output modules can be included in a bank.
• A single output module can drive up to three attached displays from any portion of
the canvas.
• The LED displays driven by the outputs can be configured with any type of tile
within a single tile category. For example:
~ All legacy tiles used: Output 1 (MiPIX), Output 2 (DLite 7), Output 3
(OLite 612)
Inpu
t
Inpu
t
Inpu
t
Ou
tpu
t
Sy
s
te
m
Po
wer
Bl
ank
Bl
ank
Bl
ank
Multi-input, single output
Bank 1
Inpu
t
Ou
tpu
t
Sy
s
te
m
Po
wer
Ou
tpu
t
Inpu
t
Bl
ank
Bl
ank
Bl
ank
Bank 1
Multi-input, dual output