Barco DX-700 - Manual (Page 180)

180 DX-700 • User’s Guide • Rev 02
^K==péÉÅáÑáÅ~нбзел
Pinouts
asfJf=`зееЙЕнзк=máåçìíë
The DX-700 uses DVI-I connectors for both inputs and outputs, but pinouts and signals are
very different, as follows.
• The following connectors use standard DVI pinouts and signals:
~ Input Module: EXP OUT connector
~ Input Module: DVI / EXP IN connector
~ System Module: DVI Monitor Output connector
Refer to the “ Standard DVI-I Connector ” section on page 181 for details.
• The following connector uses proprietary DVI pinouts and signals:
~ DVI Output Module: LED OUT 1, 2, and 3 connectors
Refer to the “ Proprietary DVI-I Connector ” section on page 182 for details.