Barco DX-700 - Manual (Page 142)

142 DX-700 • User’s Guide • Rev 02
4. Operation
DX-700 Management Menu Operations
rëáåÖ=íÜÉ=bíÜÉêåÉí=jÉåì
The Ethernet Menu enables you to view Ethernet status and manage Ethernet properties.
„
Use the following steps to view and manage Ethernet properties:
1. From the Home Menu, press {DX-700 Management}.
2. Press {Ethernet} to display the Ethernet Menu .
Figure 4-77. Ethernet Menu (sample)
3. The top Ethernet Status section lists the status, the speed and the duplex mode.
If required, press {Refresh} to update the status.
The middle IP Address section lists the current IP address, the MAC address,
and the port.
4. In the IP Mode section, press either the Static IP or DHCP Client radio button to
change the system’s current Ethernet mode.
5. To change the static IP address:
a. In the IP section, press any of the four quads to display a Keypad.
b. Enter the new value for the quad and press OK.
c. Press {Apply} to accept the new value, then in the Mode section, press
the Static IP radio button to activate the new address.
6. To change the subnet mask:
a. In the Subnet section, press any of the four quads to display a Keypad.
b. Enter the new value for the quad and press OK.
c. Press {Apply} to accept the new value.
7. Press {Save} to save any changes you made on the Ethernet Menu.
8. Press {Previous} to return to the DX-700 Management Menu. If any changes
were made but not saved, you will be prompted to save changes.
This completes the Ethernet Management procedure.