Barco DX-700 - Manual (Page 175)

DX-700 • User’s Guide • Rev 02 175
^K==péÉÅáÑáÅ~нбзел
Genlock Specifications
kkf=lìíéìí=jçÇìäÉ
The table below lists DX-700 NNI output module specifications.
dÉåäçÅâ=péÉÅáÑáÅ~нбзел
The table below lists DX-700 genlock specifications.
Table A-3. DX-700 NNI LED Output Module Specifications
Parameter Detail Specification
Output Module NNI NNI interface, supports next generation Barco LED arrays
Connectors 3 x HDMI-type
Maximum resolution
per output Up to 2048 either horizontally or vertically. Maximum active area:
768K pixels (e.g., 768 x 1024)
Note Outputs transmit 12 bits per RGB component, per pixel
Warning The HDMI-type connectors on the NNI output module use
proprietary signals and pinouts.
Do not connect the output of an NNI output module to
anything other than the input of a Barco NNI LED tile. Even
though the connector is an HDMI-type connector, it is not an
HDMI signal, and serious damage could result if, for example,
the output is plugged into an HDMI-type monitor.
Table A-4. DX-700 Genlock Specifications
Parameter Detail Specification
Genlock Input Csync (standard or tri-level), or H+V (TTL Level)
Connector 2 x BNC supporting composite sync, black burst, or separate H
and V. No loop-through.
Termination 75 ohm, +/- 0.1%
Expansion Sync Output Connects to H/CS genlock input of slave DX-700 unit
Connector 1 x BNC