Barco DX-700 - Manual (Page 49)

DX-700 • User’s Guide • Rev 02 49
2. Hardware Orientation
DX-700 Rear Panel
kkf=lìíéìí=jçÇìäÉ
The figure below illustrates the DX-700’s NNI Output Module.
Figure 2-9. DX-700 NNI Output Module
1) Thumb Screws
Two captive, spring-loaded Thumb Screws are provided to secure the module
into the DX-700 chassis.
2) Latches
Two Latches are provided to ensure precise module insertion and extraction.
Care is required when inserting or removing modules. Refer to the “
Module
Insertion and Extraction ” section on page 57 for instructions.
3) NNI Outputs
Three HDMI-type connectors are provided for NNI Outputs, which connect to new
LED products such as NX-4. Each output can drive one attached display from any
portion of a selected source image, and each output is limited to a maximum
resolution of 1024 x 768.
1) Thumb Screws 3) NNI Outputs
2) Latches
LE
D
OU
T
1
L
E
D
O
U
T 2
L
E
D
OUT 3
2
2
1
1
3