Adjusting image processing parameters, Adjusting image, Processing parameters – Barco DX-700 User Manual
Page 115: Замлнбец=fг~цй=mêçåéëëáåö=m~к~гйнйкл
DX-700 • User’s Guide • Rev 02
115
4. Operation
Using the Input Management Menu
^ЗамлнбеЦ=fг~ЦЙ=mêçÅÉëëáåÖ=m~к~гЙнЙкл
For the selected input, Image Processing adjustments enable you to adjust the input’s
contrast, brightness, sharpness, saturation, hue, clip to sub-black and luma tracking. You
can also set EDID parameters.
Use the following steps to adjust input contrast, brightness, sharpness, saturation,
hue, EDID and cable equalization:
1.
(Optional) If required, use the Preset Management Menu to recall a preset that
includes the input that you wish to adjust. This step “activates” an input. Refer to
the “
” section on page 104.
If the input is already active, no action is required in this step.
2.
From the Home Menu, press {Input Management} to display the Input
Selection Menu
.
3.
On any bank, select the input card (module) that includes the active input that you
wish to adjust. The Input Management Menu appears.
4.
Select Image Processing Tab 1 (I.P. 1).
Figure 4-49.
Input Management Menu: Image Processing Tab 1 (sample)
Perform the following adjustments as required:
~
Use the Contrast slider to adjust the contrast of the input.
~
Use the Brightness slider to adjust input brightness.
~
Use the Sharpness slider to adjust the sharpness of the input.
~
Use the Saturation slider to adjust the input’s color saturation.
~
Use the Hue slider to adjust the input’s hue.
Note
Image processing adjustments are shown on two different
tabs: I.P. 1 and I.P. 2.