Barco DX-700 - Manual (Page 81)

DX-700 • User’s Guide • Rev 02 81
4. Operation
Using the Setup Wizard
pÉíìé=tбт~кЗ=jÉåì=qêÉÉë
The Setup Wizard menu tree varies slightly, depending on the type of output module that
you are setting up. The figure below illustrates the Setup Wizard menu tree for DVI
Output Modules
:
Figure 4-5. Setup Wizard Menu Tree for DVI Output Modules
Home Menu
Setup Wizard
Setup Wizard Initial Menu
Next
Bank Selection Menu
Select Output
Display Layout Menu
Display #
Display Reset
H Output Position
V Output Position
Accept Position
Previous
Next
Test Pattern Check Menu
Grid Size No
Yes
Output Setup Complete
Next
Yes No
Return?
Note: DVI output module selected
Click physical
button in Output
Selection Pane
Panel
Display Output Selection Menu
Click physical
output connector in
rear panel view
Input Wizard
Output Frame Rate Menu
Next PAL
NTSC
Computer
Output Selection Menu
Select Bank
Yes No
Not all outputs set
up. Continue?
Test Pattern Check Menu
Grid Size
Yes No
Moving Smoothly?
Yes No
Select this output as
the reduced/minimum
delay output?
Delay mode
disabled
OK
Standard mode
pre-selected
Reduced or Minimum
mode pre-selected
Set up additional displays
Dis-similar Tiles Similar Tiles
If two or three
outputs are set up
Select one of the outputs
as the reduced/minimum
delay output?
Yes No
Delay Output Selection Menu
Display Next
If one output
is set up
If two outputs
are set up
Wall Positioning Menu
Apply Set Columns
Set Rows Next
Yes No
Rolling Smoothly?
Output Position Menu
H Position
V Position
H Size
V Size
Next
Set Direction
Set Start
Display
If all outputs
are set up
Delay Mode Dependency
If one output
is set up
If one output
is set up
If two or three
outputs are set up
Select Output
Setup Dependency
Setup Dependency
Setup Dependency