Operation – Barco DX-700 User Manual
Page 132
132
DX-700 • User’s Guide • Rev 02
4. Operation
Using the Display Management Menu
7.
To generate a test pattern from the Fiberlink transmitter, press {Transmitter} to
display the Transmitter Pattern Generation Menu.
Figure 4-69.
Transmitter Pattern Generation Menu
a.
In the Pattern Generation section, check the Enabled check box to
enable transmitter test patterns.
b.
Select a test pattern. Each pattern has additional options:
•
When Byte Level is enabled:
–
Select the desired color: Red, Green, Blue or All.
–
Adjust the Amplitude with the slider.
•
When Multiburst is selected:
–
Select the desired color: Red, Green, Blue or All.
–
Select the horizontal motion: Still, Left or Right.
–
Adjust the Burst Type with the slider.
•
When Vertical Ramps is selected:
–
Select the desired color: Red, Green, Blue or All.
–
Select the vertical motion: Still, Up or Down.
•
When Horizontal Ramps is selected:
–
Select the desired color: Red, Green, Blue or All.
–
Select the horizontal motion: Still, Left or Right.
•
When Cross Hatch is selected:
–
Select the desired color: Red, Green, Blue or All.
–
Select the horizontal motion: Still, Left or Right.
–
Select the vertical motion: Still, Up or Down.
–
Adjust the Pixel Width with the slider.
c.
Press {Previous} to return to the Fiberlink Processing Menu.
8.
To generate a test pattern from the Fiberlink receiver, press {Receiver} to display
the Receiver Pattern Generation Menu.
a.
In the Pattern Generation section, check the Enabled check box to
enable receiver test patterns.