Barco DX-700 - Manual (Page 14)

14 DX-700 • User’s Guide • Rev 02
NK==fåíêçÇìÅíáçå
Firmware Version
cáêãï~êÉ=sÉêëáçå
This version of the DX-700 User’s Guide is based on firmware version 2.30.
`Ь~йнЙк=píêìÅíìêÉ
The following chapters provide instructions for all aspects of DX-700 operations:
• Chapter 1, “ Introduction ” provides a system overview, a list of features, and a
system connectivity diagram.
• Chapter 2, “ Hardware Orientation ” on page 33 provides detailed diagrams of the
DX-700’s front and rear panels.
• Chapter 3, “ Installation ” on page 61 provides comprehensive system installation
instructions.
• Chapter 4, “ Operation ” on page 69 provides menu trees, plus comprehensive
DX-700 operating instructions.
• Chapter 5, “ Upgrading Firmware ” on page 167 outlines procedures for
upgrading DX-700 firmware.
• Appendix A, “ Specifications ” on page 171 lists the DX-700’s specifications.
• Appendix B, “ Remote Control Protocol ” on page 185 provides information
regarding remote control commands and protocol.
• Appendix C, “ Contact Information ” on page 203 lists important Barco contact,
RMA, warranty and technical support details.
• Appendix D, “ Fiberlink NNI Installation ” on page 205 provides setup and
operating instructions for the optional Fiberlink NNI Multi-mode Transmitter and
Receiver.