Barco DX-700 - Manual (Page 191)

DX-700 • User’s Guide • Rev 02 191
_K==oÉãçíÉ=`зенкзд=mêçíçÅçä
DX-700 Remote Command List
auJTMM=oÉãçíÉ=`згг~еЗ=iáëí
The following command categories are presented in this section:
• Output LED Commands
• Output Fiberlink Commands
• Monitor Output Commands
• Preset Commands
• Miscellaneous Commands
lìíéìí=iba=`згг~еЗл
p`omto
• Description : Turn on/off all devices (tile and Fiberlink) connected to the specified
output ID.
• Set format : SCRPWR | Bank | Out | Pwr
• Parameters :
~ Bank: Bank ID 1 – 3
~ Out: Output ID 1 – 6
~ Pwr: Power mode [ 0 | 1 ] .. 0 = OFF, 1 = ON
S
Example: SCRPWR | 1 | 4 | 1
• Query format : SCRPWR? | Bank | Out
• Query returns : Pwr | Min | Max
~ Pwr: Power Mode
~ Min: Min Power Mode
~ Max: Max Power Mode
S
Example: SCRPWR? | 2 | 1
1 | 0 | 1
t^ii`lkqo
• Description : Set / Query the wall (digital) contrast.
• Set format : WALLCONTR | Bank | Out | Contr
• Parameters :
~ Bank: Bank ID 1 – 3
~ Out: Output ID 1 – 6
~ Contr: Contrast value [ 0 – Max Contrast ] .. in NIT
Note Max Contrast can be queried, refer to query format below.
S
Example: WALLCONTR | 1 | 2 | 200