Barco DX-700 - Manual (Page 105)

DX-700 • User’s Guide • Rev 02 105
4. Operation
Using the Preset Management Menu
3. Press the button for the bank on which you want to recall a preset. The Preset
Recall Menu
appears.
Figure 4-40. Preset Recall Menu
4. In the Preset List, navigate to the preset that you wish to recall, using the controls
to the right of the list, or simply press the preset to highlight it.
5. By default, the {Apply over black} check box is selected.
~ When this check box is checked, the output goes to black momentarily
when you recall a preset.
~ When the option is un-checked, the system cuts to the new preset, with
the possibility of a visible glitch between the previous and new preset —
depending on the recalled parameters.
6. Press {Recall} to recall the selected preset to the bank. All output and input
assignments (as stored in the preset for the selected bank) are restored.
A pop-up message confirms that the preset has been restored, and the system
remains on the Preset Recall Menu, enabling you to recall additional presets.
oЙе~гЙ=~=mêÉëÉí
„
Use the following steps to rename a preset:
1. From the Home Menu, press {Preset Management} to display the Preset
Management Menu
.
2. Press {Preset Recall} to display the Bank Selection Menu.
3. Press the button for the bank on which you want to rename a preset. The Preset
Recall Menu
appears.
Tip For presets that include multiple changes, use the {Apply
over black}
option to hide the changes by having the wall
momentarily go black — for example, if a preset will re-lock to
a new source and change the wall contrast.