Barco DX-700 - Manual (Page 158)

158 DX-700 • User’s Guide • Rev 02
4. Operation
DX-700 Management Menu Operations
rëáåÖ=íÜÉ=bñéÉêí=jÉåì
The figure below illustrates the Expert Menu.
Figure 4-95. Expert Menu
The Expert Menu enables you to perform the following functions:
• Pre-select one of three delay modes, which affect the Input and Setup wizards.
Refer to the “
Pre-selecting the Delay Mode ” section on page 159 for details.
• Reset the canvas orientation. Refer to the “ Refreshing the Canvas Size ”
section on page 160 for details.
• Change the output timing. Refer to the “ Setting Output Timing ” section on
page 161 for details.
• Enable the {Autosave} check box to automatically save the state of all banks,
inputs and outputs in a single register after 15 seconds of inactivity. This register
is recalled when you power up the DX-700.
When the check box is un-checked, autosave is disabled and all “saves” must be
performed manually.
Note That this is the same function as pressing the {Save} button
on the DX-700 Management Menu.