ADS Environmental Services Profile Software 950015B6 - Manual (Page 104)

2-64 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 – 2012 ADS LLC. All Rights Reserved.
enter a number in the following format when sending a
text message: 2561234567.
− For email, enter the wireless provider’s SMS/mail
Gateway number and the recipient’s email address
separated by a colon. At this time, ADS uses only
AT&T wireless service; therefore, all email addresses
should read in the following format:
+121:[email protected]
 Select the method through which communication with the
recipient will occur from the corresponding drop-down list.
SMS represents text message recipients; email represents
email recipients.
 Repeat the previous two steps for up to two more
individuals or entities (in the Recipient 2 and 3 fields) you
want to be contacted for check-in or concerning an alarm
or event.
Peak Combo Device
Edit the Peak Combo Sensor 1 (or 2) device associated with a
FlowShark Triton or FlowHawk monitor that represents the upward-
looking ultrasonic depth, pressure, and velocity sensors in the
following way.
The Edit Peak Combo 1 (or 2) Parameters consists of four tabs
for editing the individual ultrasonic, pressure, velocity, and
temperature parameters. Use these parameters to configure the peak
combo sensor device.
The following parameters are located in the Device Parameters
section at the lower portion of the Edit Peak Combo 1 (or 2)
Parameters window and are relevant to the physical installation of
the sensor.