ADS Environmental Services Profile Software 950015B6 - Manual (Page 267)

Communications 5-9
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
conditions and project requirements. Following monitor activation,
you can upload the LIF from the monitor at any time using the ADS
Qstart
™ software.
Perform the following steps in the Communications tool to activate a
monitor or group of monitors:
Warning: Do not attempt to reactivate a FlowShark
monitor using the Communications tool if you are adding
any devices to or removing any devices from the
configuration. Reactivating the monitor after making
changes to the devices selected will render all data stored in
the monitor memory inaccessible. ADS recommends using
the Diagnostics tool to reactivate monitors receiving a new
configuration including a modified device selection.
Reactivate a monitor using the Communications tool only
when the device selection remains unchanged.
Comm.
button
1. Access the Communications tool from the Profile main screen
by selecting the group or monitor location with which you want
to communicate and then selecting the Communications
toolbar button.
Activate
button
2. Select the Activate button from the Communications toolbar.
Go button
Schedule
button
3. Either choose the Go toolbar button to initiate activation for the
selected locations, or choose the Schedule toolbar button to
delay activation for a later, more convenient time.
Profile schedules activation for or activates the selected location(s).
Warning: If the Profile database resides on a network, it is
essential that your local system is logged onto the network
for the task scheduler to initiate scheduled activations.
Therefore, do not log off from the network when activations
are scheduled to occur.