ADS Environmental Services Profile Software 950015B6 User Manual
Page 244
4-22
Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
Curve Properties dialog, Setup tab
1. In the Max X field, use the default value of the pipe height or
adjust this value to use only the scattergraph points below the
Max X value to generate a curve.
2. In the Num Bins field, use the default value or enter the
number of vertical bins (points) you want to use to generate the
curve.
3. In the Max Weight field, use the default value or enter another
weighting value to use for all bins when generating the curve.
Note: The weight of each bin is equal to the number of
points in the bin up to Max Weight.
4. Generate a Bestfit HC or a Bestfit Roughness and Slope. Refer
to Generating a Bestfit HC on page 4-23 or Quantity
Coefficient Generator on page 4-24 for more information.