ADS Environmental Services Profile Software 950015B6 - Manual (Page 285)

6-14 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
 Serial Port Select the proper port for serial communication
from this drop-down list. This list should include all available
ports on your computer.
 DMI Port Select the proper port for communication using
the DMI cable from this drop-down list. This list should
include all available ports on your computer.
 Timeout Enter the number of seconds you want your local
computer to wait for a response from the monitor once
communication has been initiated. (Default value is 80.)
 Retries Enter the number of times you want your local PC
to request data from the monitor following failed attempts
while the monitor is still on line. (Default value is 3.)
 Low Temperature Enter the temperature reading from the
monitor, ultrasonic depth sensor, and pressure depth sensor
below which you want Profile to provide notification.
(Default value is 32
° F.)
 High Temperature Enter the temperature reading from the
monitor, ultrasonic depth sensor, and pressure depth sensor
above which you want Profile to provide notification.
(Default value is 120
° F.)
 Log Communications Select this checkbox to record all
communication activities with the monitor.
 Status on Connect Select this checkbox to view details of
the current state of the monitor when monitor communications
are established. If you do not want to view the monitor status
details at connect, do not select this checkbox.
 Low Battery Enter the voltage below which you want
Profile to provide notification for each designated monitor
series. ADS recommends leaving the default battery settings
unchanged.
Note: Notification of low battery voltage or signal strength
occurs during the data collection process, during monitor
activation, and when receiving TCP/IP communication status.