ADS Environmental Services Profile Software 950015B6 - Manual (Page 96)

2-56 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 – 2012 ADS LLC. All Rights Reserved.
− Select the Close button to exit the graph and return to
the Edit MLI Device Properties dialog.
Note: Select the View button in the Typical Days section
at any time to display the typical days data for the selected
location.
• Dual Data Rate Set up the monitor to temporarily increase
the data log rate in response to a depth trigger (threshold).
 Option Select Depth Limit to temporarily increase the
log rate to the Fast rate (defined in the Properties for
location [location name] dialog for the selected monitor
location) once flow exceeds the user-defined Depth
Threshold. The log rate returns to the Normal rate once
the flow depth falls back below the designated threshold.
 Depth Threshold Enter the flow depth above which you
want the monitor to temporarily increase the log rate to the
fast rate.
• Unidepth Averaging Use this option when using High
Depth Alarms, High High Depth Alarms, Low Depth Alarms,
or Daily Depth Pattern (Low Flow) Alarms to allow the
monitor to average the Unidepth data (which these alarms are
based upon) to help prevent erroneous readings from
triggering false alarms.
 Readings to Average Select the number of consecutive
Unidepth readings you want the monitor to average to
minimize the impact of erroneous readings on the data.
 Store Data Select this checkbox to save the averaged
Unidepth data to the monitor memory. When the number
entered into the Readings to Average field is greater than
1, the monitor creates and stores the new entity,
DMLI_AVG (DML2_AVG for monitoring point 2), which
is collected and stored in the Profile database.
• Sampling Edit the Sampling parameters to manage water-
quality sampling activities.