ADS Environmental Services Profile Software 950015B6 - Manual (Page 506)

14-26 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
Entering the Pseudo Site Time Span
Enter the beginning and ending dates and times for which you want
to generate QPseudo data in the Calc Start and Calc End fields.
Selecting a Data Averaging Interval
Select a data averaging interval from the Interval drop-down list.
This will be the data interval generated for the Pseudo Site. For
example, select 15-Minute to generate four data points for every
hour of Pseudo Site data.
Adding Entries to the Table
Add specific time spans of selected QFinal data to the Selected
Entities table (located at the bottom of the Final Data Generator
dialog) in order to create the Pseudo Site. Add QFinal entities to
the table using the following steps:
1. Select a QFinal entity from the Available Entity list by
selecting the framed + symbol to the left of each location and
monitoring point level. QFinal entities are located just below
the monitoring point level.
2. Enter the date you want to begin using the selected entity in the
Start Date/Time field.
3. (Optional) Select a Factor Op and enter a Factor by which to
adjust the selected QFinal.
4. Select the "+" button to add the QFinal quantity to the table, or
select the "–" button to subtract the QFinal quantity from the
Pseudo Site.
The data entity is chronologically added to the Selected Entities
table.