Analog output card device – ADS Environmental Services Profile Software 950015B6 User Manual
Page 70
2-30
Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 – 2012 ADS LLC. All Rights Reserved.
• Resistor Value Enter the nominal value in ohms for the
4/20 mA circuit.
• Min Input Enter the value you want to serve as the minimum
cutoff value for the input. If a reading falls below this setting,
this value will be recorded in place of the actual reading.
Analog Output Card Device
Edit the analog output card device in the following way:
Note: The following instructions apply to all ADS
monitors using an analog input device except FlowShark
monitors. For instructions on editing an analog input
device associated with a FlowShark monitor, refer to
Analog Output Card Device (FlowShark) on page 2-31.
Edit Analog Output Device Properties
• Enable Select the checkbox corresponding to the channel for
which you want to set up parameters.