ADS Environmental Services Profile Software 950015B6 - Manual (Page 467)

12-34 Profile Software User's Guide
CONFIDENTIAL – Covered by ADS Software License Agreement
1998 - 2012 ADS LLC. All Rights Reserved.
Curve
Properties
button
1. Select the Edit > Curve Properties option or the Curve
Properties toolbar button to display the Setup tab.
2. Select the appropriate checkbox in the Tolerances section to
display the desired tolerance curve(s) on the scattergraph.
Note: The checkboxes in the Tolerances section are only
enabled after a scattergraph curve has been generated.
3. Select OK to close and exit the Setup tab.
4. Select the curve type from the Tolerance Curve drop-down list
(located below the toolbar buttons) around which you want to
draw the tolerance ranges.
Perform one or more of the following tolerance editing operations
after establishing the tolerance ranges:
• Widen or tighten the tolerance ranges.
• Move data inside the tolerance range to the graph curve using
the Snap data feature.
• Flag any data points that fall outside the tolerance range.
• Clear data flags from any data inside the tolerance range.
Widening or Tightening the Tolerance Ranges
Adjust the tolerance width using the up and down arrows located to
the right of the Tolerance field to widen or tighten the current
tolerance range. Changing the tolerance width affects which data
points are included or excluded in the tolerance range. The
scattergraph tolerance range will adjust according to the value in the
Tolerance field.