Baby Lock Palette 10 (ECS10) Instruction Manual - Manual (Page 192)

191
Tutorial 9-3: Embroidering With the Jumbo Frame
4
When embroidering is finished, follow the
instructions on the embroidery machine to
affix embroidery positioning sticker on the
embroidering area.
 The embroidery machine's built-in camera
detects the embroidery positioning sticker.
5
After the sticker have been detected, remove
the embroidery frame, rotate it 180°, and then
re-attach it to the embroidery machine.
 The embroidery machine's built-in camera
detects the embroidery positioning sticker
again.
6
Follow the embroidery machine instructions to
remove the embroidery positioning stickers.
7
Select the pattern for side 2, and then start the
embroidery machine to embroider the side 2
embroidering area.
■ Embroidery data for the jumbo
frame
• When the embroidery design is being saved in
[Layout & Editing], older file format versions are
not available.
In addition, the embroidery design is saved as
data specifically for our multi-needle embroidery
machines equipped with a built-in camera. It
cannot be sewn with any other machine.
• An embroidery pattern created in a Design Page
set to the jumbo frame size in [Design Center]
cannot be transferred directly to the machine.
Import the embroidery pattern into [Layout &
Editing], and then transfer it to the embroidery
machine.
b
An image of the needle location appears in the
screen with the positioning detection area framed
by a line.
Affix an embroidery positioning sticker so that it fits
within the line. For details, refer to the Operation
Manual for the machine.
b
• For details on using the embroidery machine,
refer to the Operation Manual included with it.
• Carefully remove the embroidery frame and
reattach it correctly. If the embroidery frame is
not correctly attached or if there is slack in the
fabric, the embroidery pattern may become
misaligned.