Baby Lock Palette 10 (ECS10) Instruction Manual - Manual (Page 64)

63
Drawing Shapes
1
Click the [Home] tab.
2
Click [Shapes] in the [Tools] group, and then
click a tool icon under [Outline] to select the
desired Outline tool.
: Click points to draw a closed line
constructed of straight lines.
(Shortcut key: <Z>)
: Click points to draw a closed curve.
(Shortcut key: <X>)
: Drag the pointer to draw a closed
freehand curve.
: Click points to draw an open line
constructed of straight lines.
(Shortcut key: <Z>)
: Click points to draw an open curve.
(Shortcut key: <X>)
: Drag the pointer to draw an open
freehand curve.
3
Click in the Design Page or drag the pointer to
draw the line.
■ Straight lines/curves
1
Click in the Design Page to specify the start
point.
2
Click in the Design Page to specify the next
point.
 The dotted lines change to solid lines.
3
Continue clicking to specify every point, and
then double-click the last point, or press the
<Enter> key.
Drawing outlines (straight
lines and curves)
End point
Start point
Open line Closed line
End point
Start point
Open curve Closed curve
b
The shortcut keys are available only after an
Outline tool has been selected.
b
• To remove the last point that was entered, right-
click the mouse button, or press the
<BackSpace> key.
• The Curve tool is used in the same way.