Baby Lock Palette 10 (ECS10) Instruction Manual - Manual (Page 88)

87
Checking Embroidery Patterns
The Jump Stitch Trimming function can be turned on
or off.
Select a frame, and then click .
About Minimum jump stitch length for thread
trimming
• The jump stitch length can be specified on the
[Output] tab into the [Design Settings] dialog
box. (To displayed it, click , then [Design
Settings]).
• If the jump stitch length is less than the length
specified for [Minimum jump stitch length for
thread trimming], the thread will not be cut,
even if [Jump Stitch Trimming] has been set.
• Whether or not [Minimum jump stitch length
for thread trimming] is available differs
depending on the selected machine model. For
details, refer to the Operation Manual for the
machine.
Jump Stitch Trimming
a
These settings are applied only when
embroidering with our multi-needle embroidery
machines. Before these settings can be specified,
select under [Machine Type] in the
[Design Settings] dialog box.
cc
"Specifying the Design Page Settings" on
page 14
The Jump Stitch Trimming button ( ) is available
in the [Sewing Order] pane.
ON OFF
b
• appears if the thread trimming setting is not
the same for all patterns in a frame with
beside it.
• The thread is cut before the thread color is
changed, even if [Jump Stitch Trimming] has
been turned off for the frame.
• Click the [View] tab, and then select the [View
Thread Trimming] check box in the [View
Mode] group. To view the thread trimming
locations in the Design Page.