Hypertherm THC ArcGlide User Manual
Page 162
Advertising
162
ArcGlide THC Instruction Manual 806450
3 – Operation
Top edge rounding: There is a slight rounding along the top edge of the cut surface.
Dross
High-speed dross: A small, linear bead of molten material attaches and hardens along the bottom edge of the cut. In
addition, S-shaped lag lines are present; dross is difficult to remove and requires grinding.
Low-speed dross: A bubbly or globular accumulation of molten material attaches and hardens along the bottom edge of
the cut. In addition, vertical lag lines may be present; dross is easy to remove and flakes off in large chunks.
Top spatter: A light spatter of molten material collects on the top edges of the cut. Usually, this spatter is
inconsequential and is most common with air plasma.
Advertising
This manual is related to the following products: