Hypertherm THC ArcGlide - Manual (Page 65)

ArcGlide THC Instruction Manual 806450 65
2 – Installation
3 – ArcGlide THC with discrete connection to a Picopath interface CNC and HPR130/260 or HPR130/260XD plasma system
CNC I/O cable
ArcGlide control module
Optional ArcGlide HMI
Rotary address switch, set to 1
Rotary address switch,
set to 1
Lifter I/O cable
Discrete plasma interface board (141094) Arc voltage sense wires
ArcGlide lifter
Shielded Ethernet cable, up
to 61 m (200 feet) long
Plasma I/O cable
Serial cable supplied by the
table manufacturer
RS-422 serial port
Serial cable supplied by
the table manufacturer
To CNC RS-422 serial port,
terminate as required
DB37 (female)
DB37 (male)
HPR control board
Cable 223192 without serial
(with red band)
To plasma
interface board
Cable 223192
without serial (with
red band)
DB50
(male)
HPR130/260 or HPR130/260XD plasma system
DB37 (female)
Picopath interface CNC
Axes 3, 4
Axes 1, 2
I/O