3 – operation – Hypertherm THC ArcGlide User Manual
Page 163
Advertising
ArcGlide THC Instruction Manual 806450
163
3 – Operation
Surface finish
Roughness: Depending on the type of metal being cut, some roughness should be expected; “roughness” describes
the texture of the cut face (the cut is not smooth).
Aluminum
Top: Air/Air
Best for thin material under 3 mm (1/8 inch)
Bottom: H35/N
2
Excellent edge quality
Weldable edge
Mild steel
Top: Air/Air
Clean cut
Nitrided edge
Increased surface hardness
Bottom: O
2
Exceptional edge quality
Weldable edge
Color
Color results from a chemical reaction between a metal and the plasma gas that is used to cut it. Color changes are to be
expected and vary most dramatically with stainless steel.
Advertising
This manual is related to the following products: