Hypertherm THC ArcGlide - Manual (Page 86)

86 ArcGlide THC Instruction Manual 806450
2 – Installation
Ground the control module
To ground the control module:
1. Remove the top nut and washer of the grounding assembly on the front of the control module.
2. Fit the ground wire terminal over the grounding post.
3. Replace the top nut and washer on the ground post and finger-tighten it so the terminal is in contact with the washer
and the bottom nut.
4. Connect the other end of the ground wire to a terminal on the table ground bus bar on the cutting machine.
See Recommended grounding and shielding practices on page 55 for more information.
Figure 19
See Operating the control module on page 135 for more information.