8 usb endpoint n fifo alarm register (epnfar), Usb endpoint, 8 usb endpoint n fifo alarm register (ep n far) – Freescale Semiconductor MCF5480 User Manual
Page 918
MCF548x Reference Manual, Rev. 3
29-44
Freescale Semiconductor
29.2.5.8
USB Endpoint n FIFO Alarm Register (EPnFAR)
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
R
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
0
W
Reset
Uninitialized
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
R
0
0
0
0
ALRMP
W
Reset
Uninitialized
0
0
0
0
0
0
0
0
0
0
0
0
Reg
Addr
MBAR + 0xB45C (EP0FAR); 0xB48C (EP1FAR); 0xB4BC (EP2FAR); 0xB4EC (EP3FAR);
0xB51C (EP4FAR); 0xB54C (EP5FAR); 0xB57C (EP6FAR)
Figure 29-48. USB Endpoint n Alarm Register (EPnFAR)
Table 29-43. EPnFAR Field Descriptions
Bits
Name
Description
31–12
—
Reserved, should be cleared.
11–0
ALRMP
Alarm pointer. The functionality of this field depends on the direction of the FIFO. The direction,
type, and packet size are defined in the EPnSTAT registers.
For Transmitter (IN): The user writes these bits to set the low level “watermark”, which is the point
at which the FIFO asserts its request for data filling to the DMA controller. This value is in bytes.
For example, with ALARM = 32, the alarm condition will occur when the FIFO has 32 (or less)
bytes in it. The alarm, once asserted, will not negate until the high level mark is reached, as
specified by the granularity bits in the EPnFCR.
For Receiver: The user writes these bits to set the low level “watermark”, which is the point at
which the FIFO asserts its request for data emptying to the DMA controller. This value is in bytes.
For example, with ALARM = 32, the alarm condition will occur when the FIFO has 32 (or less) free
bytes in it. The alarm, once asserted will not negate until the high level mark is reached, as
specified by the granularity bits in the EPnFCR.