INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual User Manual
Page 104
2 - 84
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
Message Area . . . . . . . . . . PLC Disabled is displayed when Disabled is
selected from the list of Port (9600, E, 7, 2) items on
the PLC Comm pane of the I/O tab. This can be
accessed by clicking Edit >> System and selecting
the I/O tab. Refer to
section 2.3.3.6.4 on page 2-52
PLC Disabled is also displayed if the Port (9600, E,
7, 2) or Address (CJ1) are invalid and cause a
communication error. See
.
Figure 2-64 Error window
PLC Enabled is displayed when PLC
communication is detected and a valid comm
serial bus has been selected from the list of Port
(9600, E, 7, 2) items on the PLC Comm pane of
the I/O tab, accessed by clicking Edit >> System
and selecting the I/O tab (refer to
section 2.3.3.6.4 on page 2-52
), and Address
(CJ1) has been assigned a working value
(usually 0).
Init.Config.xml is displayed when the
IQS-233 Codeposition software is started.
The name of a selected configuration file is
displayed.