INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 66)

2 - 46
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
Full Scale Out (V) . . . . . . . . 0.0 to ±10.0
Enter the desired value for the source output voltage
at 100% Power. This value can be from -10.0 to
+10.0 (the + sign is not required), but must not
exceed the maximum input voltage allowed for the
equipment connected to the source output on the
IQM-233 or SQM-242 card.
Color . . . . . . . . . . . . . . . . . . Click the Color box corresponding to an Output and
select a color from the color palette to be used for the
corresponding Output Power, Rate, and Deviation
graph. The Color also changes the color of the Film,
Rate, Deviation, Thickness, and Power values on
the IQS-233 Codeposition window (see
Figure 2-54
on page 2-72 ).
Test Output . . . . . . . . . . . . . 1 to 6
Select the number of the Physical Output to be
tested. Use the Full Scale and Zero commands to
test the selected Physical Output. Verify with a digital
multimeter.
Full Scale . . . . . . . . . . . . . . Forces the selected Physical Output to its Full Scale
Out value.
Zero . . . . . . . . . . . . . . . . . . Zeroes the selected Physical Output.