INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 50)

2 - 30
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
New . . . . . . . . . . . . . . . . . . . Displays the New Film Name window where a name
for a new set of Film parameters can be entered.
When a new name is entered and the New Film
Name window is closed by clicking OK, the new
name is displayed in the Film box and the default
Process configuration is displayed in the Deposit,
Condition, Source/Sensor, and Errors tabs. These
Film parameters can then be changed as needed
and saved under the new name. The original Film
name is not deleted from the list of Film names. See
Figure 2-27 .
Figure 2-27 New Film Name window
Delete . . . . . . . . . . . . . . . . . Deletes the currently displayed Film name from the
list of Film names.
NOTE: If the Film to be deleted is used in a Process,
a message will display the name of any
Process where the Film is used. The Film
must be deleted from any Process where
the Film is used before the Film can be
deleted from the list of Film names.
CAUTION
Delete cannot be undone.
Copy . . . . . . . . . . . . . . . . . . Displays the Copy Selected Film to New Film
Name window where a duplicate of the currently
displayed Film parameters can be named and
saved. See
Figure 2-28 .
Figure 2-28 Copy Selected Film to New Film Name window