INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 41)

2 - 21
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
2.3.3.5.3 Layer Information and Edit Commands
A Process consists of the Layer(s) displayed in the Layer information pane (see
Figure 2-21 ). A Layer consists of the parameters configured in the Layer tab (see
Figure 2-22 on page 2-23 ) and Rate Ramps tab (see Figure 2-23 on page 2-26 ).
Figure 2-21 Process window - Layer information and edit commands
Layer . . . . . . . . . . . . . . . . . . Click the number of the desired Layer to display the
parameters in the Layer and Rate Ramps tabs
pertaining to that Layer.
NOTE: All related Codeposition Layers have the
same Layer number, but each Codeposition
Layer must use a different Output.
Out . . . . . . . . . . . . . . . . . . . The name of the source Output mapped to a
physical source output connection on the IQM-233
or SQM-242 card. Refer to the IQM-233 or SQM-242
operating manual for information about the source
output connection. The Output name is selected in
the Layer tab (see
Figure 2-22 on page 2-23 ). The
relationship between the Output name and the
physical output connection on the IQM-233 or
SQM-242 card is configured in the Outputs tab of the
System Setup window (see
Figure 2-37 on page
2-45 ).