6 command buttons – INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual User Manual
Page 94
2 - 74
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
2.3.6 Command Buttons
Figure 2-56 IQS-233 Codeposition window - command buttons
Start Simulate
Abort Simulate . . . . . . . . . . Displayed if the Simulate check box is selected in the
Card tab of the System Setup window. Click Start
Simulate, which changes to Abort Simulate, to start
a simulated Process. Click Abort Simulate, which
changes to Start Simulate, to stop the simulated
Process.
Start Process
Abort Process . . . . . . . . . . Click Start Process, which changes to Abort
Process, to start a Process. Click Abort Process,
which changes to Start Process, to stop the Process.
Start Layer, Stop Layer . . . Click Start Layer, which changes to Stop Layer, to
start a Layer. Click Stop Layer, which changes to
Start Layer, to stop the Layer.
Next Layer. . . . . . . . . . . . . . Abort Simulate changes to Next Layer after reaching
Final Thickness of a layer, when clicking Stop Layer,
or when an error causes the process to stop.
Clicking Next Layer increments the Layer number to
the next Layer of a Process.