INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 109)

2 - 89
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
15b Click Enabled or Ethernet Enabled to enable RS-232 or Ethernet remote
communication, respectively. Refer to
section 2.3.3.6.6 on page 2-58 .
15c Click OK to save changes.
16 Click Edit >> System and select the Display tab (refer to Figure 2-36 on page
2-44 ).
17 Select Display and Graph settings to be viewed in the IQS-233 Codeposition
window, refer to
section 2.3.3.6.7 on page 2-60 .
18 Click OK to save changes.
19 Click File >> Save to save the current Process and System parameter values
to the configuration filename displayed in the message area of the
IQS-233 Codeposition window. If the default configuration file, InitConfig.xml, is
displayed, the default parameters loaded when IQS-233 Codeposition software
is started will be overwritten by any changes made to the Process and System
parameters.
19a Click File >> Save As to save the current Process and System
configuration under a different name. Configuration files are saved in .xml
format. The default folder to save a configuration file to is C: >> INFICON
>> IQS-233 Codeposition; however, the configuration file may be saved
to another folder location if desired (refer to
Figure 2-11 on page 2-13 ).
20 Click Edit >> System and select Card tab (refer to Figure 2-41 on page 2-56 ).
21 Select Enabled in the Simulate pane.
22 Click OK to save changes.
23 Click Start Simulate on the IQS-233 Codeposition window (refer to Figure 2-56
on page 2-74 ) to simulate the process prior to making an actual deposition.
NOTE: Disconnect outputs from the IQM-233 or SQM-242 card(s) to prevent the
supply of power to source outputs.
2.4.6 Starting a Process
1 If in Simulate Mode:
1a Click Edit >> System and select Card tab (refer to Figure 2-41 on page
2-56 ).
1b Deselect Enabled in the Simulate pane.
1c Click OK to save changes.
2 Connect the appropriate inputs and outputs to IQM-233 or SQM-242 card(s).
NOTE: Refer to the IQM-233 or SQM-242 operating manual for information
about the physical input and output connections.