INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 21)

2 - 1
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
Chapter 2
IQS-233 Codeposition Software
2.1 Introduction
This chapter covers the installation and operation of IQS-233 Codeposition
software. Refer to the IQM-233 or SQM-242 operating manual for installation
instructions of an IQM-233 card or SQM-242 card.
2.2 Installing IQS-233 Codeposition Software
IQS-233 Codeposition software supports up to two IQM-233 cards or up to two
SQM-242 cards.
CAUTION
If IQM-233 and SQM-242 cards are installed together in
the same computer, IQS-233 Codeposition software will
communicate with up to two IQM-233 cards and ignore
the SQM-242 card(s).
IQM-233 card(s) must be removed to use
IQS-233 Codeposition software with SQM-242 card(s).
The required Dynamic Link Library (DLL), device driver, and WinDriver are installed
by the IQM233 DLL or the SQM242 with IQM DLL setup file. To install the DLL,
device driver, and WinDriver, see
section 2.2.1 .
CAUTION
IQM233 DLL and SQM242 with IQM DLL cannot be
installed together on the same computer.
NOTE: IQS-233 Codeposition software and the IQM233 DLL or SQM242 with
IQM DLL may be installed before or after the installation of the IQM-233 or
SQM-242 card(s). Refer to the IQM-233 or SQM-242 operating manual for
card installation instructions.