INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 87)

2 - 67
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
For a sequential Layer, the name of the Film used in the Layer is displayed at the
top of the pane.
For a Codeposition Layer, the names of the Films used in the Layers comprising
the Codeposition Layer are displayed at the top of the pane.
 The name displayed at the top of the name list corresponds to the Layer using
the lowest numbered physical output.
 The name at the bottom of the list corresponds to the Layer using the highest
numbered physical output.
NOTE: The physical output number for an Output name is configured in the
Outputs tab of the System Setup window.
Select the Film name corresponding to a particular Layer of the Codeposition Layer
to display the frequently used parameters for that Layer.
Figure 2-51 IQS-233 Codeposition window - frequently used Layer parameters for PID loop control