INFICON IQM-233 Thin Film Deposition Controller PCI-Express Card Codeposition Software Operating Manual - Manual (Page 65)

2 - 45
IP
N 07
4-
58
5-
P1
A
IQS-233 Operating Manual
2.3.3.6.1 Outputs Tab
The source Outputs are configured in the Outputs tab. See Figure 2-37 .
Figure 2-37 System Setup window - Outputs tab
Name . . . . . . . . . . . . . . . . . . Outputs 1 to 6 (IQM-233 cards)
Outputs 1 to 4 (SQM-242 cards)
A new name for an Output can be entered in the
Name box.
NOTE: Output 1 to Output 3 are displayed if one
IQM-233 card is installed. Output 1 and
Output 2 are displayed if one SQM-242 card
is installed.
Physical Output # . . . . . . . . None, 1 to 6 (IQM-233 cards)
None, 1 to 4 (SQM-242 cards)
The Physical Output number mapped to the same
numbered source output connection on the IQM-233
or SQM-242 card. Refer to the IQM-233 or SQM-242
operating manual for information about the source
output connections.