Lenze EVS93xx CrossCutter - Manual (Page 112)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-98
3.2 Installing the Cross Cutter prepared solution
A CD containing all necessary data is provided (see Chapter 1.2). An installation wizard installs
the data on the PC automatically. The user is guided step for step through the installation by the
installation wizard.
Using the programmable variant of the prepared solution cross cutter the user is asked for a
password by starting the programm master CrossCutter_SPLC_Vxxxxxx.lpc or
CrossCutter_ECS_Vxxxxxx.lpc. The user has permission for Level 2, here you just have to
press the OK Button and for Level 1, the password is lenze.
TIP!
Passwort Level 2: without typing in any password press the OK Button.
Passwort Level 1: lenze
3.3 Hardware structure
Gearbox knife drum:
z
2
: z
1
Gearbox infeed drum:
z
2
: z
1
Diameter of infeed drum:
d
master
Knife drum feed constants
Digital frequency coupling
Encoder
Reference initiator
"Cross Cutter” drive 9300
Servo PLC or ECS
Application