Lenze EVS93xx CrossCutter - Manual (Page 242)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-74
The signal sources for the data words (designated Word 0, Word 1, Word 2 and Word 3) are
dependent on the operating mode in C4000/000:
Signal source Word 0 Word 1 Word 2 Word 3
C4000/000 = 0 C0135/000 C4137/000 C4135/000
C4000/000 = 1 CAN1_wDctrlCtrl CAN1_nInW1_a CAN1_nInW2_a CAN1_nInW3_a
C4000/000 = 2 CAN2_nInW1_a CAN2_nInW2_a CAN2_nInW3_a CAN2_nInW4_a
C4000/000 = 3 CAN3_nInW1_a CAN3_nInW2_a CAN3_nInW3_a CAN3_nInW4_a
C4000/000 = 4 AIF1_wDctrlCtrl AIF1_nInW1_a AIF1_nInW2_a AIF1_nInW3_a
C4000/000 = 5 AIF2_nInW1_a AIF2_nInW2_a AIF2_nInW3_a AIF2_nInW4_a
C4000/000 = 6 AIF3_nInW1_a AIF3_nInW2_a AIF3_nInW3_a AIF3_nInW4_a
The illustration of the 32-bit application control word (Word 3 and Word 4) on the previous page
shows the factory-set default configuration. Users can also adapt the configuration of the
application control word in accordance with their individual needs by setting the values of codes
C4010/001 to C4010/032 accordingly.
An example of how the GDC parameterisation software can be used to reconfigure the
application control word bit by bit appears below:
You will find the code in the complete code list or in the menu (Short Setup Control/Status Interface
Control Interface):
Select code C4010/00x which is assigned to the function to be configured.
Example: The control signal for manual jog in a positive direction is defined in code C4010/004:
Start
Step 1