Lenze EVS93xx CrossCutter - Manual (Page 133)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-119
Start GDLoader and run a search for all drives connected to the system bus. GDLoader will scan the system
bus and find the servo drive:
Next, assign the files to the required servo axis by clicking the corresponding icons in the left-hand column:
Step 6
Step 5
Click the required servo controller (in the example, this is
the controller with system bus node address 1) and
confirm with Ok.
Select the following file as the DDS binary file:
Project:
For Servo PLC: CrossCutter_SPLC_Vxxxxxx.bin
For ECS: CrossCutter_ECS_Vxxxxxx.bin