Lenze EVS93xx CrossCutter - Manual (Page 207)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-39
6.2 Prepared solution codes
6.2.1 Table of application codes
In addition to the system codes (see 9300ET ServoPLC documentation) in the prepared
solution, the settings that are important for the function of the machine can be made using
application codes starting at C3000/000.
Possible settings: Code
Default Selection
Comment
Homing mode
0 >_Rn_MP
1 <_Rn_MP
4 >_Rp_<_Rn_MP
5 <_Rp_>_Rn_MP
6 >_Rn_>_TP
7 <_Rn_<_TP
8 >_TP
9 <_TP C3010/
000
0 0 {1} 9
Symbols for code C3010:
> Movement in positive direction
< Movement in negative direction
Rp Positive edge of homing switch
Rn Negative edge of homing switch
TP Touch-probe edge of input I4 for 9300 Servo PLC and I2 for
ECS
MP Zero pulse edge of motor
(one per motor revolution)
The execution of the last action in each case will set the home
position (e.g. the zero pulse in the case of "MP") even if the drive
continues to move subsequently.
C3303/
000
- - - - Display code: Master gearbox numerator
C3304/
000
- - - - Display code: Master gearbox denominator
C3305/
000
- - - - Display code: Master feed constant
C3306/
000
- - - - Display code: Slave gearbox numerator
C3307/
000
- - - - Display code: Slave gearbox denominator
C3308/
000
- - - - Display code: Slave feed constant
C3350/
000
- - {1[m_units]} - Display code: Master angle setpoint
C3351/
000
- - {1[m_units]} - Display code: Current master angle
C3355/
000
- - {1[s_units]} - Display code: Current position
C3356/
000
- - {1[s_units]} - Display code: Profile set position
C3357/
000
- - {1[s_units]} - Display code: Auxiliary integrator
C3359/
000
- - {1[s_units]} - Display code: Following error
C3360/
000
- - {1[incr.]} - Display code: Master angle setpoint