Lenze EVS93xx CrossCutter - Manual (Page 150)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-136
Now set the specific parameters for length-controlled operation.
Start with the settings for the cutting profile (Short Setup Cross Cutting Operation Settings Cutting
Profile):
Make the following code settings:
C3655/000 Setpoint cutting length
Enter the setpoint length here at which you wish the continuous material to be processed.
The value is entered in [m_units].
 Caution!
Entering a cutting length of 0 is impermissible and will lead to an error when calculating the
motion profile!
TIP!
See Chapter 2.5.1 for more information.
Step 2