Lenze EVS93xx CrossCutter - Manual (Page 226)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-58
Code Initialisation Comment
C4012/022 21,0000 Status bit 21 output to output bit 21, synchronus cutting operation
C4012/023 22,0000 Status bit 22 output to output bit 22, Cutting mode
C4012/024 23,0000 Status bit 23 output to output bit 23, Reject mode
C4012/025 24,0000 Status bit 24 output to output bit 24, Test mode
C4012/026 25,0000 Status bit 25 output to output bit 25, Open reject gate
C4012/027 26,0000 Status bit 26 output to output bit 26, Maximum missed marks exceeded
C4012/028 27,0000 Status bit 27 output to output bit 27, Print mark controller enabled
C4012/029 28,0000 Status bit 28 output to output bit 28, Print mark register active
C4012/030 29,0000 Status bit 29 output to output bit 29, Knife in material (sync angle)
C4012/031 30,0000 Status bit 30 output to output bit 30, NC
C4012/032 31,0000 Status bit 31 output to output bit 31, Profile calculations done