Lenze EVS93xx CrossCutter - Manual (Page 217)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-49
Possible settings: Code
Default Selection
Comment
C4012/
001
002
003
004
005
006
007
008
009
010
011
012
013
014
015
016
017
018
019
020
021
022
023
024
025
026
027
028
029
030
031
032
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
0 {1} 31 Configuration codes for the status interface: Each subcode
defines, for a specific status bit, the source of the status
information:
The single subcodes are assigned with the following Bits:
001:
Bit 0
002: Bit 1
….
032:
Bit 31
The following status information, can be assigned free of choice
to the 31 Bits:
0: Trip
state
1: Follow error warning
2: Follow error trip
3: Positioning active
4: Positioning done
5: Lock to cam busy
6: Cross Cutter Operation
7: Print mark correction active
8: Recalculation of cutting profile
9: Recalculation of reject profile
10: Recalculation of test profile
11: Recalculation of start/stop profile
12: Calculation of cutting profile OK
13: Calculation of reject profile OK
14: Calculation of test profile OK
15: Calculation of start/stop profile OK
16: Homing busy
17: Home position available
18: Homing error
29: NC
20:
asynchronus cutting operation
21: synchronus cutting operation
22: Cutting mode
23: Reject mode
24: Test mode
25: Open reject gate
26: Maximum missed marks exceeded
27: Print mark controller enabled
28: Print mark register active
29: Knife in material (sync angle)
30: NC
31:
Profile calculations done
The cross-cutter axis can be monitored via the status interface.
The default values are set via code initialisation.