Lenze EVS93xx CrossCutter - Manual (Page 142)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-128
Make the parameter settings for manual jog (Short Setup Manual Operation):
TIP!
See Chapter 2.5.4 for more information about manual jog.
Make the following code settings:
C3622/001 Inching mode: Deceleration ramp
C3622/003 Inching mode: Acceleration ramp
C3623/001 Inching mode: Positive speed
C3623/002 Inching mode: Negative speed
Step 6