Lenze EVS93xx CrossCutter - Manual (Page 141)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-127
Call up the parameters for configuring the cross-cutter axis
(Short Setup Cross-Cutter Axis Data):
Make the following code settings:
C3501/000 Selection of application units [m_units]
C3636/000 Motor mounting direction
C3653/000 Cutting circle circumference
C3654/000 Cutting angle (synchronous angle)
C3668/000 Distance mark sensor - cutting position
C3679/000 Distance cutting position - reject gate
C3683/000 Speed limiter: Upper speed limit
C3684/000 Speed limiter: Lower speed limit
Step 5