Lenze EVS93xx CrossCutter - Manual (Page 259)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-91
Inputs (Variable type: VAR_INPUT)
Name Data type Value/Meaning
Indicates that the cross cutter knife is not in Material. Connect this value to variable
g_bKnifeNotInMaterial.
TRUE The cross cutter knife is not in material.
bKnifeNotInMaterial BOOL
FALSE The cross cutter knife is in material.
Outputs (Variable type: VAR_OUTPUT)
Name Data type Value/Meaning
nxVelTrimmingFactorOut_v INT Speed signal which can be used to perform manual x trimming. This value must be
added to the master speed of the x axis.
Inputs/Outputs (Variable type: VAR_IN_OUT)
Name Data type Value/Meaning
dnOutTpPos_p DINT Position signal used for manual x trimming. Connect this value to variable
dnTpPos_p of the L_CamSetXAxisVelocity function block.
Note: Assign a retain variable to this input/output!
In order to be able to use the full functionality of the XPositionTrimming function block, you need
to create 7 codes.
The specific variables used for this purpose are:
Variable Value/Meaning
Name Data type Value/Meaning
DINT Variable for acceleration time when using bTrimPosDirection and
bTrimNegDirection. The acceleration and deceleration times relate to a change in
the output value from 0 to 100% (100% = 16384).
Possible settings
Default Selection
xxx.L_RFG1.dnTir
0.000 s 0.000 {0.001 s} 999.999
DINT Variable for deceleration time when using bTrimPosDirection and
bTrimNegDirection. The acceleration and deceleration times relate to a change in
the output value from 0 to 100% (100% = 16384).
Possible settings
Default Selection
xxx.L_RFG1.dnTif
0.000 s 0.000 {0.001 s} 999.999
ARRAY OF DINT Variable for deceleration ramp to stop before reaching the set position
( bExecuteSetPositionTrimming = FALSE) when using variables
dnSetPositionTrimming_p and bExecuteSetPositionTrimming.
The ramp assumes 4000 rpm.
Possible settings
Default Selection
xxx.L_CamPosCtrlLin1.adnTiPos[1]
1.000 s 0.010 {0.001 s} 130.000