Lenze EVS93xx CrossCutter - Manual (Page 224)

Cross Cutter
Appendix
 Prepared Solution Servo PLC / ECSxA 1.1 EN 6-56
Possible settings: Code
Default Selection
Comment
Application status word bit 28: Using print-mark register.
TRUE
Use the print-mark register.
C4150/
000
Bit 28
- - - -
FALSE Do not use the print-mark register.
Application status word bit 29: Knife is in material.
TRUE Knife in material.
C4150/
000
Bit 29
- - - -
FALSE Knife not in material.
Application status word bit 30: Not assigned
TRUE
C4150/
000
Bit 30
- - - -
FALSE
Application status word 31: All calculation sequences for new
cross-cutter motion profiles have been completed successfully.
Starting a new calculation sequence will reset this status output to
FALSE.
TRUE
All calculation sequences for new cross-cutter motion
profiles have been completed successfully.
C4150/
000
Bit 31
- - - -
FALSE Some calculation sequences for new cross-cutter
motion profiles are still in progress.
C4152/
000
- - - - Display code: Current application status word