Lenze EVS93xx CrossCutter - Manual (Page 145)

Cross Cutter
Installing and starting up the "CrossCutter" prepared solution
 Prepared Solution Servo PLC / ECSxA 1.1 EN 3-131
You now need to make the settings for the Lock To Cam parameters
Short Setup Cross Cutting Operation Lock To Cam):
TIPP!
See Chapter 2.5.1 for more information about Lock To Cam.
Make the following code settings:
C3630/000 Positioning mode Lock To Cam
0= Move to target position via shortest way.
1 = Move to target position only in positive direction (CW).
2 = Move to target position only in negative direction (CCW).
Step 9